24V Pallet E-roller

Die NDW Motorrollen für Palettentransport sind bürstenlose Gleichstrommotoren, die in eine konventionelle NDW Tragrolle mit ø63,5 / 70 / 80 / 89 mm integriert sind und in erster Linie dazu dienen, nicht-selbstangetriebene Rollen in Fördersystemen anzutreiben (max. Geschwindigkeit 0,35 m/s).

73493 PP NDW palletroller afbeeldingen aangepast DU

E-roller transmissions

Pallet E-rollers can be equipped with poly-v and chain headers for transmission.

The selection is based on the requirements of the application.

73493 PP NDW palletroller afbeeldingen

E-roller controllers

Each motorized E-roller must be connected to a compatible NDW motor controller such as the BC50 or BP120 controller. All controllers are designed to precisely control the behaviour of the motorized roller.

73493 PP NDW palletroller afbeeldingen3

Technical Data

1. Actual current is depended on the conditions of the application, such as actual load, section length, slope etc. A very short current peak of <40ms will occur during startup of the E-roller.

2. Measured at 1 meter. Also dependent on the conditions of the application, such as conveyor frame, mounting type, load and resonance behavior of the system

73493 PP NDW palletroller afbeeldingen4

Performance data

These values are given as guideline. Actual transfer capacity depends on application parameters such as nature of transported load, quality of the bearings, duty-cycle, type of transmission to non-driven rollers etc.

73493 PP NDW palletroller afbeeldingen5

Dimensions of the Pallet E-roller

The dimensions of the E-roller depend on the type of transmission. When ordering a E-roller, the IL-value (enclosed length or frame width) should be used. Since NDW also manufactures the non-driven rollers, alignment between E-rollers and other rollers can be garantueed.

For other tube diameters, transmission types or mounting type contact NDW.

73493 PP NDW palletroller afbeeldingen6

Mounting of the motorized E-roller

The motorized pallet E-roller can be mounted in any pallet conveyor frame consisting of hexagonal holes (min. 11.2 mm) or round holes (min 12.2 mm).

To prevent the roller from twisting in the conveyor frame, one could use the ER-locking plate. This stainless-steel plate has a narrow tolerance and can be slid over the ER50 shaft. The locking plate can be mounted in multiple directions to ease installation.

Available accessories

E-roller extension cable

1500mm, two-sided connector, male/female, order code: 901-CABMOT-1500

3000mm, two-sided connector, male/female, order code: 901-CABMOT-3000

E-roller mounting lock

ER-Lock, stainless steel, order code: 901-ERLOCK-1A