The NDW High Speed E-rollers are brushless DC motors integrated in a conventional ø50/60mm NDW roller with the primary purpose to drive non-driven rollers in conveyor systems. (max. speed 3 m/s ø50mm).
1. Actual current is depended on the conditions of the application, such as actual load, section length, slope etc. A very short current peak of <40ms will occur during startup of the E-roller.
2. Measured at 1 meter. Also dependent on the conditions of the application, such as conveyor frame, mounting type, load and resonance behavior of the system.
E-roller transmissions
Within the ER50 series, E-rollers can be equipped with different transmission alternatives such as poly-v, grooves, toothed belts and round belts. The selection is based on the requirements of the application.
Performance data - 1200 RPM
These values are given as guideline. Actual transfer capacity depends on application parameters such as nature of transported load, quality of the bearings, duty-cycle, type of transmission to non-driven rollers etc.
E-roller controllers
Each motorized E-roller must be connected to a compatible NDW motor controller such as the BC50 or BP120 controller. All controllers are designed to precisely control the behaviour of the motorized roller.