De NDW Pallet E-roller bestaat uit de conventionele ø 63,5 / 70 / 80 / 89 mm NDW-rol met een geïntegreerde borstelloze gelijkstroommotor. Primaire doel van deze rollen is het aandrijven van niet-aangedreven rollen in transportbandsystemen. De maximale snelheid bedraagt 0.35 m/s.
Pallet E-rollers can be equipped with poly-v and chain headers for transmission.
The selection is based on the requirements of the application.
Each motorized E-roller must be connected to a compatible NDW motor controller such as the BC50 or BP120 controller. All controllers are designed to precisely control the behaviour of the motorized roller.
1. Actual current is depended on the conditions of the application, such as actual load, section length, slope etc. A very short current peak of <40ms will occur during startup of the E-roller.
2. Measured at 1 meter. Also dependent on the conditions of the application, such as conveyor frame, mounting type, load and resonance behavior of the system
These values are given as guideline. Actual transfer capacity depends on application parameters such as nature of transported load, quality of the bearings, duty-cycle, type of transmission to non-driven rollers etc.
The dimensions of the E-roller depend on the type of transmission. When ordering a E-roller, the IL-value (enclosed length or frame width) should be used. Since NDW also manufactures the non-driven rollers, alignment between E-rollers and other rollers can be garantueed.
For other tube diameters, transmission types or mounting type contact NDW.
The motorized pallet E-roller can be mounted in any pallet conveyor frame consisting of hexagonal holes (min. 11.2 mm) or round holes (min 12.2 mm).
To prevent the roller from twisting in the conveyor frame, one could use the ER-locking plate. This stainless-steel plate has a narrow tolerance and can be slid over the ER50 shaft. The locking plate can be mounted in multiple directions to ease installation.
• E-roller extension cable
1500mm, two-sided connector, male/female, order code: 901-CABMOT-1500
3000mm, two-sided connector, male/female, order code: 901-CABMOT-3000
• E-roller mounting lock
ER-Lock, stainless steel, order code: 901-ERLOCK-1A